The needle valve on the hydraulic cylinder on my bandsaw is not holding the cutting arm up and I cannot adjust the feed rate. I think the needle valve is not restricting the flow of the hydraulic fluid properly. If anyone has suggestions on how to repair it I would appreciate your suggestions. I can order a replacement, but it will take a week to get here from Northern Tool.
tallgrass
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
